How to Charge Car Batteries

1 Check that the batteries if there are signs of damage such as cracks, leaks, corrosion, missing lid, loose heads and so on. If there are traces of white dust divided terminals, and quick-drying water battery, possibly extended to the battery power is too high. When this occurs, it should be repaired as soon as possible, to prevent damage to the battery. Effects is unknown if there are leaks around and under the battery dusty greenish white salt.

2 Check the battery water level at least once a week. This is normally done by employees of oil pumping stations. If the water is less, add water to the battery (distilled water). Clean, cold water can also be used.
However, do not put water in excess of a specified level, as this will cause the water to overflow the battery and may cause further damage to metal parts. To guide you, fill up the black water in the flooded batteries only.

3 If there are traces of white salt dust impacts at both terminals of the battery, clean it using a mixture of sodium carbonate (baking powder - baking powder) to measure a teaspoon of powder in a cup of water. This mixture is applied on the battery terminal and it will foam. These bubbles will stop when it is clean. Then rinse with cold water normally. Strengthen ties with the head of neat battery if necessary.

4 Strengthen the battery using the battery charger if necessary. Avoid using drugs that are dikedai battery. These materials are usually recognized can strengthen the battery, but actually doing this in vain.
Air batteries are sold dikedai are of desalinated water (distilled water), but when inserted in the battery it will be mixed with water and then into a liquid battery sulfuric acid. So avoid this acid from contact with clothes or your skin. Do not add sulfuric acid into the battery.

How to turn the Car When Battery Low II

This method requires a pair of wires. This wire must be rough as the battery wire and measuring between 20 to 25 cm in length and attached clip ends. Preferably one red and one black. You also have a friend who has a car and good battery.
First of all, connect the black wire from the negative terminal (-) from the battery to the negative terminal of the battery to your friend (without removing the battery out head or any part of the battery of the car).
Second, connect the red wire from the positive terminal (+) of the battery to the positive terminal of the battery of your friends.
Third, turn on your car as usual.
Finally, after the engine life, remove the wire from the positive terminal to the negative terminal followed.

Using the push method:

This requires strong partners to push your car. First of all, turn the car key to the 'ON'. Then enter second gear and press the clutch. Give signal to your friends to start pushing the car. When the car was less upbeat, slowly release the clutch. Hopefully the engine will live. Your attention in this way can not be done on the car Geared automatically.